Space robotics · Caltech · DARPA · 2026-11-05

Caltech says its DARPA NOM4D robot assembled a truss section in space without astronauts

Photo: Caltech / Momentus

Three key points

  1. Caltech said on November 5 that its DARPA NOM4D ASTRA robot assembled a truss section in orbit without astronauts.
  2. The payload launched on March 30, 2026, on Momentus Vigoride 7 (SpaceX Transporter-16); two prebuilt bays were pushed out and a third bay was then assembled, the university said.
  3. The same article said time limits left only the initial antenna section built, and that finishing all 11 bays before the mission ends in December appears unlikely.

Story summary

The California Institute of Technology said in an official news post on November 5 that a robotic truss builder conceived, designed and built by Caltech researchers and funded by DARPA's Novel Orbital and Moon Manufacturing, Materials, and Mass-efficient Design (NOM4D) program had successfully built a structure in space without the help of astronauts. The builder is part of Caltech's Autonomous In-Space Tensioned Reflector Assembly (ASTRA) demonstration, an autonomous manipulator that picks up struts and joints from nearby dispensers to assemble identical bays of a perimeter truss. Sergio Pellegrino, the project lead, said, “This is the first time that a structure has been autonomously constructed in space.” Caltech said ASTRA has been working to construct a 1.4-meter-diameter reflector antenna from composite fiber tubes, aluminum joints and a Kapton reflective surface, and that the payload reached low Earth orbit on March 30, 2026, as one of 10 payloads on Momentus's Vigoride 7, launched on SpaceX Transporter-16 from Vandenberg Space Force Base. The payload carried two prebuilt bays and an arm-like manipulator; once in space the prebuilt bays were pushed out and assembly of the third bay was carried out, the article said. It also said the team ran into time limitations and was only able to build the initial section of the antenna, that the ASTRA truss is complete when 11 bays are finished, and that with the mission ending in December it appears unlikely the demonstration will complete the full truss assembly.

Comments 0

    Be the first to comment.